LITMIR.BIZ

Scheme 1.9 (Left) The polyacylated anthocyanins (Dangles et al. 1993); (Right) representation of the relative energy levels at equilibrium using the hydration and acidity constants reported by the authors. The construction of this type of energy level diagram is shown in Scheme 1.2. It is worth noting that two acylated units are not enough to invert the energy levels between the hemiketal (B) and the quinoidal base (A).

      Source: Dangles et al. 1993.

The protection effect of the acylated sugars for the hydration reaction was studied previously (Fernandes et al. 2015; Dangles et al. 1993), but according to our knowledge no other study of the physical chemistry of three acylated sugars has been reported. The most complete study previously published, regarding this type of molecules, was reported by Dangles et al. (1993) (Scheme 1.9). In this work, the proton transfer as well as the hydration constants were determined, allowing the construction of an energy level diagram as in Scheme 1.8.

The same type of effect reported for HBA1 was observed: raising of the energy level of the hemiketal and a more or less constant energy level of the quinoidal base as the acylated units increase.⁵ However, no inversion of the energy levels of the hemiketal compared with quinoidal base was observed, suggesting that three acylated units are necessary.⁶

The energy level diagram of the HBA1 was extended to the basic region; Scheme 1.10. Details can be found elsewhere (Mendoza et al. 2019).

After a pH jump to pH=5.5, for example, the system equilibrates between A, B, Cc, and Ct, but the most stable species is the quinoidal base A. In the case of a pH jump to the region of the mono‐anionic species, pH=8.5, the anionic quinoidal base becomes the most stable species.

Scheme 1.10 Energy level diagram of the compound HBA1 extended to the mono‐anionic species. In the case of moderately acidic pHs the purple color of the quinoidal base is observed; at higher pH values it is the blue anionic quinoidal base that becomes more stable.

      Source: Mendoza et al. 2018.

      1.4.2 2‐Hydroxyflavylium Derivatives and Flavanones

The 2’‐hydroxyflavylium derivatives give rise to the formation of flavanones as shown in Scheme 1.11 and Figure 1.6 (Petrov et al. 2008; Slavcheva et al. 2018).

      Figure 1.6 shows the spectral variations after a direct pH jump to pH=8.1 (Slavcheva, et al. 2018). A few seconds after the pH jump the anionic hemiketal and cis‐chalcone are formed (Figure 1.6a). The system evolves and gives the anionic trans‐chalcone after c. 40 minutes. However, equilibrium is reached four hours later, only after formation of the flavanone (FLV; Figure 1.6b), indicating that the flavanone is formed from the anionic trans‐chalcone. Acidification of the flavanone does not give any spectral variation, but basification to pH=12.0 very quickly gives Ct^2‐ (k_obs = 3.3 s^‐1). When the titration of Ct^2‐ by reverse pH jump is carried out, the absorption spectra of Ct^‐ and Ct are observed according to the final pH. The spectrum of Ct is stable and the one of Ct^‐ gives the flavanone as in Figure 1.6b.

Scheme 1.11 2’‐hydroxy‐5’‐methylflavylium and its derived flavanone form.

Figure 1.6 (a) Spectral variations after a direct pH jump from pH=1 to pH=8.1 of the compound 2’‐hydroxy‐5‐methylflavylium up to 40 minutes; (b) the same after 40 minutes up to 4 hours; (c) reverse pH jump from pH=12 to pH=8.4.

      Source: Slavcheva, et al. 2018. © 2018 Elsevier.

This peculiar behavior permits to illustrate the concept of a timer at the molecular level with reset capacity (Scheme 1.12).

The initial species is Ct at pH=4.0. The activation of the timer is made by changing the pH to pH=8.0, which allows the flavanone formation to start. To stop the timer the pH is reversed back to pH=4.0. The unreacted Ct^‐ immediately gives the stable Ct and the flavanone does not react. The flavanone/trans‐chalcone molar ratio gives the extension of the reaction and the elapsed time.⁷ To reset the timer two steps are needed: (i) the unlock step should be achieved by changing the pH to 12; the unreacted Ct and the flavanone (more precisely the anionic flavanone) give Ct^2‐, and (ii) after the end of the first step, the pH is shifted to 4.0 and the reaction goes back to Ct.

Scheme 1.12 Illustrating the concept of a timer with reset capacity through a metamorphosis cycle.

      Source: Slavcheva, et al. 2018. © 2018 Elsevier.

      1.4.3 6,8 Rearrangements

In Scheme 1.13, the 6,8 rearrangement is shown. Two necessary requirements are needed to observe this reaction in flavylium‐derived systems: (i) a hydroxyl group in position C5 and (ii) the lack of symmetry through the binary axis identified in Скачать книгу