LITMIR.BIZ

      2. Select Drawing Template (*.dwt) from the “Files of type” if not already selected.

      3. Select either the inch-helper.dwt or metric-helper.dwt from the list of templates.

       Note : If you do not have these templates, refer to page 2-2 for instructions.

      4. Select the Open button.

How to Select a Command

      AutoCAD provides you with 2 different methods for selecting commands.

      One is selecting a tool from the Ribbon, the other is typing the command. Both methods will accomplish the same end result. You decide which method you prefer. An example of Method 1 is shown below. Method 2 is on the next page.

       Method 1. Selecting a tool from the Ribbon

      1. First select a Tab such as Home.

      2. Locate the correct Panel such as Draw.

      3. Select a tool such as Circle.

       Note :

      If the tool includes multiple types, it will have a down-arrow

      If you select the down-arrow, a sub-menu will appear.

      Select the desired type such as 2-Point.

      The latest selection will then become the current displayed tool because AutoCAD assumes that you may need that tool again.

       Method 2. Keyboard entry

      You may type commands on the Command Line (Shown below) or in the Dynamic Input Tooltip (Shown on the next page).

      It depends on whether you have Dynamic Input on or off.

       Command Line

       How to enter a command on the Command Line.

      1. Place the cursor in the Command Line area. (Important.)

      2. Type the first letter of a command, such as c for circle.

      3. A list of commands that begin with the letter c will appear. Select the command from the list.

      4. When you enter a command such as Circle the prompt and options will be displayed on the Command Line.

      5. The prompt for Circle command asks you to:

       “Specify center point for circle" or [ 3P/2P/Ttr (tan tan radius) ]:

      The information within the [ ] brackets are options that you may select.

       Dynamic Input

      Dynamic Input is another method of inputting commands, values and select options.

      To use Dynamic Input you must turn on the Dynamic Input button in the Status Bar, shown on page 1-14.

      If you choose to use Dynamic Input, the command will be entered in the tooltip box beside the cursor.

       How to enter a command using Dynamic Input.

      1. Place the cursor in the Drawing Area. (Important)

      2. Type the first letter of a command, such as c for circle.

      3. A list of commands that begin with the letter c will appear. Select the command from the list.

      4. If you press the down arrow, the options will appear below the prompt.

      Notice the command entry and prompts are being displayed on the Command Line also.

      Using the Command Line or Dynamic Input is your choice.

Drawing Lines

      A Line can be one segment or a series of connected segments.

      But each segment is an individual object.

      Start the Line command using one of the following methods:

      Ribbon = Home Tab / Draw Panel /

       or

      Keyboard = L <Enter>

       Lines are drawn by specifying the locations

Скачать книгу